Led Lamp Steps 1-3
STEP 1 - Cut two 150mm sections of the PVC pipe using a fine toothed saw then make a deep score along its axis with a utility knife. If you compress the pipe the plastic will break at the score mark down the length of the pipe section.
STEP 2 - Heat the section of pipe in an oven at about c/f - 125/225 degrees until the plastic becomes pliable. It will be fairly hot so gloves are recommended. Remove from the oven and press between two flat surfaces. If the plastic curls after pressing and cooling repeat the process. Be careful not to over heat the plastic.
STEP 3 - Referring to the dimensions on the plans layout and cut all the required plastic pieces. The plastic is very easy to score and break to produce very accurate and strait edges. Use pliers to break away smaller peices.
